Power Electronics MCQs Part 3
Contents
- 1 Which of following doping is done to make a signal diode suitable for high current high voltage applications with minimum losses
- 2 When the PN junction diode is forward biased, the width of the depletion region
- 3 When reverse breakdown occurs in a diode
- 4 Certain transistor is operating at the middle of the load line, then a decrease in the current gain would
- 5 The N-channel MOSFET is considered better than the P-channel MOSFET due to
Which of following doping is done to make a signal diode suitable for high current high voltage applications with minimum losses
Which of following doping is done to make a signal diode suitable for high current high voltage applications with minimum losses
- A lightly doped n layer is grown between the two p and n layers
- A lightly doped p layer is grown between the two p and n layers
- A heavily doped p layer is grown between the two p and n layers
- A heavily doped n layer is grown between the two p and n layers
Correct answer: 1. A lightly doped n layer is grown between the two p and n layers
See complete list of Power Electronics MCQs
When the PN junction diode is forward biased, the width of the depletion region
When the PN junction diode is forward biased, the width of the depletion region:
- Decreases
- Increases
- Remains constant
- Increases than decreases
Correct answer: 1. Decreases
Explanation: When a diode is forward biased, the depletion layer narrows down and finally it collapses to allow the flow of electric current.
When reverse breakdown occurs in a diode
When reverse breakdown occurs in a diode
- Voltage is constant while current increases
- Voltage increases while current is constant
- Voltage increases while current also increases
- Both voltage and current are constant
Correct answer: 1. Voltage is constant while current increases
Certain transistor is operating at the middle of the load line, then a decrease in the current gain would
Certain transistor is operating at the middle of the load line, then a decrease in the current gain would
- Move the Q point down
- Move the Q point up
- Not change the Q point
- Result in to and fro motion of the Q point
Correct answer: 1. Move the Q point down
The N-channel MOSFET is considered better than the P-channel MOSFET due to
The N-channel MOSFET is considered better than the P-channel MOSFET due to:
- Faster operation
- Low noise levels
- Lower input impedance
- TTL compatibility
Correct answer: 1. Faster operation
Also see:
- Basic Electrical Laws and Theorems
- Basic Voltage and Current MCQs
- High Voltage Engineering MCQs
- Induction Motor MCQs
- Power Electronics
- Power Distribution MCQs
- Power Generation MCQs
- Power System Protection MCQs
- Synchronous Generator MCQs
- Synchronous motor MCQs
- Transformer MCQs