High Voltage Engineering MCQs Part 4
- The worst gap for measuring the voltages is:
- Field gap
- Sphere gap
- Rod gap
- All of these
- Correct answer: 3. Rod gap
- Usually Mole’s bridge is used to measure __________ frequency measurements:
- Low
- High
- Both of these
- None of these
- Correct answer: 1. Low
- Impulse tests are performed on transformers:
- To determine insulation ability against transient voltages
- To test the moisture content in fuel
- Both of these
- All of these
- Correct answer: 1. To determine insulation ability against transient voltages
- The penning effect demonstrates:
- Decrease in dielectric strength of mixture of gases
- Increases in dielectric strength of mixture of gases
- Decrease in dielectric strength of a gas
- Increase in dielectric strength of a gas
- Correct answer: 1. Decrease in dielectric strength of mixture of gases
- Usually, the switching surge is ___________by the operation of switches or breakers:
- Self-induced
- Not-induced
- According to suspended particle theory, if ε1 > ε2, then force F is directed towards:
- Minimum stress areas
- Maximum stress areas
- Both of these
- None of these
- Correct answer: 1. Minimum stress areas
- The phenomenon of corona takes place in case of:
- Alternating currents
- Direct Currents
- Both of these
- None of these
- Correct answer: 3. Both of these
- The phenomenon of treeing is expected to occur in the dielectric which has a non-uniform field. The correct statement about treeing:
- It occurs at once in single discharge
- The lower the voltages, the higher is the chance of treeing
- It occurs in two discharges
- None of these
- Correct answer: None of these
- According to bubble theory of liquid breakdown, the vapor bubble elongates __________ direction of the electric field and its volume ___________ during elongation:
- in the, increases gradually
- away from the, remains constant
- in the, remains constant
- away from the, increases gradually
- Correct answer: 3. in the, remains constant
- The gas which is employed as insulating material:
- Oxygen
- Sulphur Hexafluoride
- Tetrafluoromethane
- Ethylamine
- Correct answer: 2. Sulphur Hexafluoride
Continue reading:
- High Voltage Engineering MCQs Part 1
- High Voltage Engineering MCQs Part 2
- High Voltage Engineering MCQs Part 3
- High Voltage Engineering MCQs Part 5
- High Voltage Engineering MCQs Part 6
- High Voltage Engineering MCQs Part 7
- High Voltage Engineering MCQs Part 8
- High Voltage Engineering MCQs Part 9
- High Voltage Engineering MCQs Part 10