power-system-protection-mcqs

Power System Protection MCQs Part 10

by

Power System Protection MCQs Part 10

Power System Protection MCQs Part 10 MCQ#1

Statement: Differential protection scheme should not be employed for longer transmission lines.

Logic: It is very expensive.

  1. Both statement and logic are wrong
  2. The statement is correct, but logic is incorrect
  3. The statement is incorrect, but logic is correct
  4. Logic defends the statement

Correct answer: 4. Logic defends the statement

The instantaneous relays used for earth fault detection in motors is usually set to

The instantaneous relays used for earth fault detection in motors is usually set to _____________:

  1. 50% of the RLA
  2. 50% of the FLA
  3. 20% of the RLA
  4. 20% of the FLA

Correct answer: 4. 20% of the FLA

MCQ#3

Declaration: Ground wires can easily protect the equipment from direct lightning thunders.

X: Ground wires are used to provide protection against traveling waves

  1. X is an application of declaration
  2. Both declaration and X are incorrect
  3. The declaration is correct, X is incorrect
  4. Declaration and X explain the same fact in different words

Correct answer: 3. The declaration is correct, X is incorrect

The method in which earthing is done through a transformer is referred as

The method in which earthing is done through a transformer is referred as:

  1. Effective earthing
  2. Non-effective earthing
  3. Peterson coil earthing
  4. Flick method

Correct answer: 2. Non-effective earthing

The term non-effective earthing refers to the earthing which is done through

The term non-effective earthing refers to the earthing which is done through:

  1. Resistance
  2. Reactance
  3. Transformer
  4. All of these

Correct answer: 4. All of these

MCQ#6

Argument: Resistance earthing can’t be used for single phase loads.

Solution: Households always employ solid earthing.

  1. Argument and solution are not connected in the present context
  2. Argument leads to the solution
  3. The argument is wrong, the solution is correct
  4. Both solution and argument are wrong

Correct answer: 2. Argument leads to a solution

Explanation: The resistance earthing can’t be used for single phase loads due to which the solid earthing method is used by households.

Striker pin fuse is used for

Striker pin fuse is used for:

  1. LV circuits
  2. LV and MV circuits
  3. MV and HV circuits
  4. HV circuits

Correct answer: 2. LV and MV circuits

R.R.R.V depends on the

R.R.R.V depends on the:

  1. Inductance
  2. Capacitance
  3. Both of these
  4. None of these

Correct answer: 3. Both of these

The arc voltage is always _______________ the current

The arc voltage is always _______________ the current:

  1. Leading
  2. Lagging
  3. In phase with

Correct answer: 3. In phase with

If the time required to reach the peak value is 100 µsec and the peak re-striking voltage is 200 kV, then average RRRV is

If the time required to reach the peak value is 100 µsec and the peak re-striking voltage is 200 kV, then average RRRV is:

  1. 20 MV/µsec
  2. 2 kV/µsec
  3. 200 MV/µsec
  4. 20 kV/µsec

Correct answer: 2. 2 kV/µsec

Continue reading:

Leave a Reply